In Multisim I cannot get the numbers to display correctly and in Crocodile Clips there is only one number that displays. Apply the clock pulses and observe the output. The full sequence doesn't show on all the 7-segment displays simultaneously like I need it to, instead it still shows the sequence as it counts from 2,1,0,6,5 up and down. Synchronous Counter Design a 3-bit synchronous counter with the sequence below by using JK flip flops. The main problem I'm facing is that I cannot get the sequence to display. I'm not sure what to do to fix this problem. On Crocodile Clips only the '1' in the sequence displays and Multisim shows all the numbers but very incorrectly. I used a 5-bit ring counter using D flip-flops with a BJT transistor and 10k Ohm resistors to do this but the sequence doesn't display correctly on either of the two programs. My problem is that what exactly is the source of this (clock) pulse. I know that data isnt moved until a clock pluse comes along. The problem comes when I need to display the entire sequence on the 7-segment displays. Im trying to build a circuit using flip flops that passes data in series using multisim. I used both Multisim and Crocodile Clips to simulate my design and it works fine. I started first by designing the Up/Down counter and simulating it. I was given a project to design a Synchronous Up/Down counter which displays my sequence (2,1,0,6,5) on 5 x 7-segment displays simultaneously.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |